Knowledgebase
UnlockSamsungOnline.com > HelpDesk > Knowledgebase

Ask a question:


P7500 flashing

Solution

Firmware: http://hotfile.com/dl/145853470/c784bae/P7500XWKHD_P7500XEUKH3_XEU.zip.html

European unbranded flash Android 3.1

Software:
http://hotfile.com/dl/116309890/3e31316/I9100_Downloader.rar.html


Instructions:
1. Charge tab100%
2. Close all software running on computer (anti-virus / firewalls and any other software that runs in the background which is not vital to windows)
3. Turn off bluetooth, remove memory cards and simcard
4. Extract flasher program to a new folder and extract firmware file in same folder (in such a way you have odin3 v.185.exe the odin3.ini and the .tar.md5 and .dll file in same folder)
5. Start odin3 software (with admin rights, don't use vista)
6. Click PDA button and load the .tar.md5 file.
7. Make sure these 2 checkboxes are selected: Auto Reboot and F. Reset Time (nothing else)
8. Turn off the tab. Wait 5-6 seconds for vibration to confirm complete switch off.
9. Now, put the Galaxy Tab 10.1 tablet in Download Mode (also called Odin mode) — press and hold, until Samsung Galaxy logo appears — these keys together: Volume_DOWN+Power.
10. Wait till you a screen with options to boot into recovery or download (odin mode).
11. Press Volume Up key to boot into download mode.
12. Connect tab with computer using USB cable. Don't use USB hub and try using USB as close as possible to power input of computer
13. You should get the message "Added! !" under the Odin’s message box in the bottom left. And you should also see COM port with a number in Yellow. If you don’t get this message, than probably there is a problem with drivers. Make sure you’ve the drivers installed!
14. Now, hit the START button to begin the flashing process. When it finishes, your tablet will automatically reboot — and you can unplug the cable when Galaxy logo appears. Plus, you’ll get a PASS (with green background) message in the left-most box at the very top of the Odin. If it’s red and with FAIL written over it, the process flashing process wasn’t successful. Try again, and take care to complete the whole process without any break whatsoever.

 
Was this article helpful? yes / no
Article details
Article ID: 29
Category: Firmware-flashing
Date added: 2012-03-04 21:41:00
Views: 895
Rating (Votes): Article rated 4.7/5.0 (13)

 
<< Go back